Optimizing SO3 Systems in Multiple-Unit Plants
Summary
Installing separate SO3 flue gas conditioning systems on two units at Duke Energy's Beckjord Power Plant fixed ongoing struggles to maintain acceptable stack emission levels. Neundorfer provided one of the SO3 systems, and helped Duke Energy save money by refurbishing a system for the other unit.
"The greatest benefit is that we can now prevent emissions from ever exceeding established opacity limits, and it does not require our round-the-clock attention."
Alan Burck
Plant Engineer, Duke Energy Beckjord Station
Full Story
The Duke Energy W.C. Beckjord Power Plant, located in New Richmond, Ohio, approximately 20 miles east of Cincinnati, is an 862-megawatt-rated utility power plant with six coal-fired units each equipped with electrostatic precipitator systems. The first four units each have a Wahlco molten-sulfur flue-gas conditioning system to provide SO3 conditioning for proper precipitator operation. Neundorfer assisted with the installation of SO3 flue gas conditioning systems on the two remaining units”one new SO3 system from Neundorfer for Unit 6 and a refurbished system from another plant for Unit 5.
Initially, Units 2 and 3 shared an SO3 system, but the plant could never seem to attain the proper SO3 levels necessary for acceptable stack emission levels. So the company added a new SO3 system from Neundorfer specifically for Unit 3 and dedicated the old system to Unit 2. œEven just by separating the two units, performance improved for both, said plant engineer Alan Burck.
Still, Burck pointed out that with frequent and dramatic changes in fuel, the units could not keep up with SO3 conditioning at needed levels. The plant obtains its fuel from a wide variety of sources, so there was constant variation in the characteristics and performance of the fuel.
œThe system required an ongoing, dynamic solution, said Burck. œWe didn’t have the resources to continuously monitor and adjust precipitator conditions”it was essentially a full-time job. The plant’s operators were making reactive, manual adjustments to SO3 levels about every four hours, or whenever a problem occurred. By the time the system responded to these changes, additional adjustments were required and the cycle continued endlessly.
Duke Energy turned to Neundorfer for assistance. Neundorfer recommended theirpatented SO3 optimization software which identifies the level of ash resistivity that produces the lowest stack opacity, and dynamically adjusts the SO3 injection rate using precipitator electrical data and stack opacity as key inputs. The module continuously monitors precipitator conditions, detecting changes in precipitator electrical and emissions data, and makes ongoing adjustments in the SO3 injection rate as needed to maintain optimal resistivity and desired emission levels.
As a result of implementing this proactive SO3 optimization software module (which can be used with any SO3 system), the plant has experienced significant performance improvements across all four units, including reduced emissions, load reductions and less sulfur consumption. Burck says, œThe greatest benefit is that we can now prevent emissions from ever exceeding established opacity limits, and it does not require our round-the-clock attention.